The Bearhawk Patrol
...Everything that made the Super Cub famous with
Greater Speed, Better Climb Rate & 9 Hour Endurance.
| Top speed || 165 MPH |
| Cruise Speed || 140 MPH |
| Landing Speed || 35 MPH |
| Take-Off Roll (Gross Wt.) || 250 feet |
| Range (55 gal. @ 35%) || 900 miles |
| Empty Weight || 950+ lbs. |
| Gross Weight (Utility Stds.) || 2,000 lbs |
| Wing Span || 33 feet |
| Wing Area || 180 sq. ft.|
| Length || 22 ft, 8 in. |
| Height (3 pt.)|| 6 ft, 4 in. |
| Cabin Width || 32 in. |
| Cabin Length || 9 ft. 5 in. |
|Engine Applications 115 hp to 210 hp||
(See description of kits below.)
Basic QB Kit - $30,825
(Some welding required)
Deluxe QB Kit - $39,105
|| Quick-build Wing Kit -
Basic Fuselage Kit
(No welding required)
|| Quick-build Wing Kit -
Deluxe Fuselage Kit
When purchasing the Deluxe QB Kit subtract $280 if you already have plans.
|CRATING CHARGE (if delivered by Bearhawk Aircraft): $925 |
(if delivered by common carrier): $950 wings/ $950 fuselage
Quick-Build Wing Kit - $17,305
These wings are sold in an advanced level of completion. The top skin is completely finish riveted. The
forward edge of the bottom skin is finish riveted to the bottom flange of the main spar, and aft of the main spar the bottom skin is drilled and
dimpled as are the ribs the bottom skin is riveted to. The bottom skin is pop riveted (with a few pops) for shipment. Spars and all spar parts
are alumi-prepped, alodined, and primered with MIL-P-23377E strontium chromate epoxy primer. Wing skin interiors and all ribs are
primered with Zinc Chromate. Steel parts in the wings are primered with epoxy primer and top coated with MIL-C-22750D epoxy paint.
Quick Build wings come with ailerons and flaps 90% finished, but still requiring fabric covering. Fuel tanks are included,but must be installed.
Basic Fuselage - $15,500
Welding required. Includes finish welded fuselage frame (unpainted) and motor mount, all major fittings are
welded in place, tabs, sheet metal and minor fitting to be done by builder, landing gear, control stick assembly, rudder pedals and flap controls
are finished. Horizontal stabilizer, elevator and rudder are finish welded.
Deluxe Fuselage - $21,800
No welding required by builder. The fuselage and all fittings are completed, sand-blasted and epoxy primed.
All steel parts are coated with the epoxy primer and top coated with MIL-C-22750D epoxy paint. Sheet metal is included; cut and ready to be
assembled, but may require some trimming. Door and frames, seat frames and the fiberglass nose bowl are included.